Location:Home>>News>>Company News
Hydraulic motor maintenance steps |
Hydraulic motor repair: 1, the repair of the stator, rotor rotor repair for deburring, grinding, mild hair or wear to use; Severe wear can brush plating to repair the cylindrical, or measuring with wire walking silk processing after tooth shape, then through change new parts after heat treatment. Stator of ejector pin for, such as tooth mild hair or wear with again after the deburring, grinding; Severe wear to enlarge diameter processing new needle teeth in use; If not for the ejector pin tooth, can change as well as the rotor machining. 2, oil distribution axle or oil distribution disc repair The oil distribution axle repair, mild hair or wear with again after the deburring, grinding; Severe cases can brush plating to repair the cylindrical or reprocessed. Oil distribution disc repair, wear A plane strain, mild impairment to grind with; Severe cases by flat grinding, the surface of the reoccupy after nitriding. Oil distribution disc Grinding or grinding pan surface repair Disassembling methods: L, clamp the motor on the vise 2, remove end cover 3, discharge of core horse 4, unload the shaft 5, shell turn clamp ring on the vise 6, unload the relevant parts of the shaft sealing system 7, check the shaft seal parts damage h, step 8, ready to remove the oil seal tool 8, use special tools for shaft seal and dust-proof sealing ring, step 10, I use plug 9, pull out or insert the output shaft 10, with inside and outside the set of tools to seal and shield ring load within the flange cover 11, the output shaft insert body shell 12, loading flange cover 13, will have a clip on the vise 14 and marked into the core of the motor 15, install back cover The above content is provided by hengtong hydraulic co., LTD., ningbo hengtong hydraulic co., LTD., specializing in the production of hydraulic motor, the country ordering website: www.cihanweb.com |